PIC programlama ufak yardım

32-bit
29-12-2015, 14:13   |  #1  
32-bit avatarı
OP Taze Üye
Teşekkür Sayısı: 0
1 mesaj
Kayıt Tarihi:Kayıt: Ara 2015

 

Aşağıdaki programa 2 küçük ekleme yapmak istiyorum ama başaramadım abilerim bi el atarmısınız
-tümü çıkış
-tüm çıkışlar 0
-tüm çıkışlar 1
-0. ve 2. biti söndür
-1. ve 3. biti söndür
-2. ve 3. biti yak bekle.


HELLOWORLD

/**
*************************************************************************
* Lesson 1 - "Hello World"
*************************************************************************
* NOTE: See Low Pin Count Demo Board User's Guide for Lesson Information
*************************************************************************
*
* The LEDs are connected to input-outpins (I/O) RC0 through RC3. First, the I/O pin
* must be configured for an output. In this case, when one of these pins is driven high
* (RC0 = 1 ), the LED will turn on. These two logic levels are derived from the power pins
* of the PIC MCU. Since the PIC device?s power pin (VDD) is connected to 5V and the
* source (VSS) to ground (0V), a '1' is equivalent to 5V, and a '0' is 0V.
*
*
* This turns on DS1 LED on the Low Pin Count Demo Board.
*
* PIC: 16F1829
* Compiler: XC8 v1.10
* IDE: MPLABX v1.50
*
* Board: PICkit 3 Low Pin Count Demo Board
* Date: 6.1.2012
*
*/

#include <xc.h> //PIC hardware mapping

//config bits that are part-specific for the PIC16F1829
#pragma config FOSC=INTOSC, WDTE=OFF, PWRTE=OFF, MCLRE=OFF, CP=OFF, CPD=OFF, BOREN=ON, CLKOUTEN=OFF, IESO=OFF, FCMEN=OFF
#pragma config WRT=OFF, PLLEN=OFF, STVREN=OFF, LVP=OFF

/* -------------------LATC-----------------
* Bit#: -7---6---5---4---3---2---1---0---
* LED: ---------------|DS4|DS3|DS2|DS1|-
*-----------------------------------------
*/

//Every program needs a `main` function
void main(void) {
TRISCbits.TRISC0 = 0; //using pin as output
LATC = 0; //clear all pins to 0
LATCbits.LATC0 = 1; //turn ON the LED by writing to the latch
while(1) continue; //sit here forever doing nothing, think "while(true), continue in this loop"

Robotik Forum
25-03-2020, 12:49   |  #2  
Taze Üye
Teşekkür Sayısı: 0
1 mesaj
Kayıt Tarihi:Kayıt: Mar 2020

Sorularına Robotik Kodlama Platformu robotikforum.net'i kullanarak cevap bulabilirsiniz

Son Düzenleme: Robotik Forum ~ 25 Mart 2020 12:50